I went for a traditional looking pair of horns and I didn't want a Postman Pat wishy-washy single beep either. I wanted a distinctive pair of hooters that beeped a proper beep.

Mounting could have been in a hundred different places but I wanted them to be seen; so it was on the drivers side on the inside front of the chassis.

The bracket was made from a surplus air-conditioning unit bracket I had. It needed modifying though. I was going to rivet it onto the chassis but I decided to tap a couple of M6 threads and bolt it on. I also drilled and tapped for another earthing point (the middle M6 bold.) Never know when I might need it. I also had to extend the wiring too as the engine loom wires were not long enough for this position.